A3D Products Manual
      Calibrating in WindowsManual Table of ContentsInstall Notes for DOS power users

      Calibrating for DOS Games

      The DOS calibration procedure will set up the Panther/Assassin 3D and your joystick or your Panther XL for DOS games. This procedure will only need to be performed once. You will however need to repeat the procedure if you install a different joystick. For an in depth explanation of these steps refer to Running the Assassin 3D DOS Calibration and Test.

      You may either use the supplied shortcut "DOS Calibration and Test" in your StartMenu/Programs/Madcatz folder or the following.

      1. Click Start, then select Programs followed by MS-DOS Prompt

      2. Change to the folder where you installed the drivers, "cd\madcatz" (default) and tap ENTER.

      3. Type "panther" and tap ENTER.

      4. Proceed to calibrate and test your joystick following the on screen prompts.

      5. When finished type "exit" and tap ENTER to return to Windows.

      Refer to Joystick Pros and Cons for help selecting your type of joystick

      Calibrating in WindowsManual Table of ContentsInstall Notes for DOS power users

      Home - Gamer's Corner - Support - What's New
      This page was last updated 06/13/04